Re: [gti-vr6] The prototype $1.42 mod

["Billy T." <btylaska@onramp.net>]

Keeps the hot coolant from ever getting to the TB, and heating the intake air.

"Smile 8)" wrote:

> What is this mod supposed to do?  I'm missing the point.
>
> Thanks,
> joey
> 95 F red
>
> On Sun, 25 Apr 1999 MAOberer@aol.com wrote:
>
> > Here's a mod that everyone may try (at their own discretion, I accept no
> > responsibility, thats why its a prototype).
> >
> >       What I did was buy a small splicing connection 3/8" o.d (called a
> > barb) and bypassed the pre-heater on the throttle body.  I live in a very
> > warm climate, and so there is not much use in having it.  What you do is buy
> > this small brass barb, and with a set of pliars you can take off the two
> > tubes that connect to the throttle body on the right hand side.  **Watch the
> > squirt of green car blood as you detach them.  Place the barb in between
> > these two hoses and then either put the existing clamps around the ends, or
> > buy fuel line O clamps (recommended).
> >       Like I said in the beginning, this is a prototype design, not sure if
> > it is efficient, but I HAVE noticed a power difference.  But of course, you
> > are all adults, and need to use your own discretion.  Email me if you have
> > any questions or comments about this procedure...
> >
> >
> > Matt
> > 95 Vento GLX "Sucking cold air in New Mexico" edition
> > --
> > For info on: how to subscribe & unsubscribe, the list's tech/how-to
> >     library, etc.  see:   http://www.panix.com/~aqn/GTI_VR6/gti_vr6_list/
> >