[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [gti-vr6] The prototype $1.42 mod
What is this mod supposed to do? I'm missing the point.
Thanks,
joey
95 F red
On Sun, 25 Apr 1999 MAOberer@aol.com wrote:
> Here's a mod that everyone may try (at their own discretion, I accept no
> responsibility, thats why its a prototype).
>
> What I did was buy a small splicing connection 3/8" o.d (called a
> barb) and bypassed the pre-heater on the throttle body. I live in a very
> warm climate, and so there is not much use in having it. What you do is buy
> this small brass barb, and with a set of pliars you can take off the two
> tubes that connect to the throttle body on the right hand side. **Watch the
> squirt of green car blood as you detach them. Place the barb in between
> these two hoses and then either put the existing clamps around the ends, or
> buy fuel line O clamps (recommended).
> Like I said in the beginning, this is a prototype design, not sure if
> it is efficient, but I HAVE noticed a power difference. But of course, you
> are all adults, and need to use your own discretion. Email me if you have
> any questions or comments about this procedure...
>
>
> Matt
> 95 Vento GLX "Sucking cold air in New Mexico" edition
> --
> For info on: how to subscribe & unsubscribe, the list's tech/how-to
> library, etc. see: http://www.panix.com/~aqn/GTI_VR6/gti_vr6_list/
>