Re: VR6 Clutch

[ANDREW_ATWELL@HP-PaloAlto-om20.om.hp.com]

     Where is your dealer located?  I would go 1000's of miles for that 
     type of treatment!
     andy


______________________________ Reply Separator _________________________________
Subject: VR6 Clutch
Author:  Non-HP-deecee (deecee@exit109.com) at HP-PaloAlto,mimegw6
Date:    8/21/97 7:33 PM


The VR6 engine uses a similar clutch setup as a Audi 80,90,100,Porsche 
944,944 turbo,VW Type 1,Type 2,Dasher,Quantum.
They use a conventional flywheel,diaphragm pressure plate,clutch disk, and 
a clutch release bearing. However in all cases the weakest link is the 
clutch release bearing sleeve.  The VR6 Jetta GLX is no different. We are 
starting to replace clutches at low miles. My boss is covering them under 
warranty even though close inspection reveals the damage has been done by 
customer abuse. "Hot Rodding." 
     
My Service Manager  wants to maintain a high CSI rating so therefore the 
technicians are paying due to cheap warranty reimbursement from VW.
     
So to all the GLXers with clutch complaints it may be due to a release 
bearing sleeve that has gone dry. "I hope not from Hot Rodding"
     
Don