[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
FW: Hood Lifts
> Did the hood lifts this weekend. Very easy job. 50 of the best bucks I
> spent. Big thanks to the archives and Mike, John and Erik for the
> instructions. The only thing I did differently (at least not mentioned in
> the write up) was cut a slot in the foam rubber spacer attached to the
> hood. I put a lift on both sides. One lift held the hood open but I felt
> a stiff wind would have caused a concussion in my future.
>
> *Actual* construction time was about 20 minutes total. Of course it took
> me two trips to Pep Boys and Home Depot after one of the stupid ball point
> bolts sheered off while tightening! I took it back to PB and they were
> "gracious" enough to give me a replacement. I said bad steel, they said
> over-tightening. Shearing off a 5/16 bolt with a short crescent wrench by
> hand? Seems unlikely. So after picking up a bolt extractor at Home
> Depot, I drilled out the remnants of the bolt (without the extractor as it
> turned out). So total time on the project was about 2 hours, if nothing
> went wrong it would have been about 20 minutes!
>
> Marc
> 97' GLX - Red/Black
>