Re: Autotech Upper Stress Bar

[Dp Scene <dpscene@yahoo.com>]

Mounted mine myself. Was fairly simple. Had to undo that nut at the
top of the strut( so I could pull down the strut assembly with car
jacked up) to give me some room to tighten the stress bar nuts/bolts.
Otherwise, just mark and drill. Make sure the stress bar adjustment
nut is centered so you have adjustment room both ways after you have
it mounted.If you undo the strut bolts at the bottom plan on getting
an alignment afterwards. I didnt need to remove  the lower strut
nuts/bolts. 




---Patrick Sherman <patrick@eurospeed.org> wrote:
>
> I got my Autotech upper stress bar today. I was reading thought the
> installations directions. It says with ABS you have to drill an
additional
> hole? Anyone done this mod themselves.. Is it pretty much lay it
down drill
> the holes and bolt it down then tighten the bar and bracket bolts..
> ?
> 
> ---PATRICK SHERMAN
> patrick@eurospeed.org
> http://www.eurospeed.org
> 97' JETTA GLX / 30K / Tornado Red
> 
> 

_________________________________________________________
DO YOU YAHOO!?
Get your free @yahoo.com address at http://mail.yahoo.com