Convience Close

[deecee@exit109.com]

If the one of the windows lags a little when closing this will cause the
convience close feature to go out of time. If this happens follow these
instructions to resync. Be VERY careful when unscrewing the plug connector
at the door jambs. It is very easy to knock the female end loose which
means removing the "B: pillar to reinstall.

Switch ignition on.
Lower all windows to Full open position.
Open sunroof to full open position.
Disconnect each power window regulator connectors at the A or B pillars.
Switch ignition off for.

Allow 5 minutes.

Switch ignition on.
Connect left front window connector at A pillar. Raise left front window to
full position.
Repeat with the right front.
Repeat with left rear.
Repeat with right rear.
All windows should be now closed.

Using the key in the drivers door operate the convience open feature and
lower all windows to full open position.
Operate convience close feature (close all windows to full close position)
continue holding key and sunroof should now close.

I hope this helps.

Don